Teldat bintec W1002n Instrukcja Użytkownika Pobierz pdf (Strona 347)

100

101

The menu Advanced Settings consists of the following fields:

Fields in the Advanced Settings menu.

Field Description

Alive Check Only for Phase-1 (IKE) Parameters

Select the method to be used to check the functionality of the

IPSec connection.

In addition to the default method Dead Peer Detection (DPD),

the (proprietary) Heartbeat method is implemented. This sends

and receives signals every 5 seconds, depending on the config-

uration. If these signals are not received after 20 seconds, the

SA is discarded as invalid.

Possible values:

• " (default value): Your device detects and uses

the mode supported by the remote terminal.

• 60: Your device sends and expects no heartbeat. Set

this option if you use devices from other manufacturers.

• ; @:% ,A: Your device expects a

heartbeat from the peer but does not send one itself.

• ; @ ,A: Your device expects no heart-

beat from the peer, but sends one itself.

• ; @ J:%A: Your device expects a

heartbeat from the peer and sends one itself.

• 7 ! 7: Use DPD (dead peer detection) in

accordance with RFC 3706. DPD uses a request-reply pro-

tocol to check the availability of the remote terminal and can

be configured independently on both sides. This option only

checks the availability of the peer if data is to be sent to it.

• 7 ! 7 @6A: Use DPD (dead peer de-

tection) in accordance with RFC 3706. DPD uses a request-

reply protocol to check the availability of the remote terminal

and can be configured independently on both sides. This op-

tion is used to carry out a check at certain intervals depending

on forthcoming data transfers.

Only for Phase-1 (IKEv2) Parameters

Enable or disable alive check.

Teldat GmbH

16 VPN

bintec WLAN and Industrial WLAN 333

1 2 ... 342 343 344 345 346 347 348 349 350 351 352 ... 553 554

Komentarze do niniejszej Instrukcji

Brak uwag

Teldat bintec W1002n Instrukcja Użytkownika Strona 347

Komentarze do niniejszej Instrukcji