Teldat bintec W1002n Instrukcja Użytkownika Strona 378

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 554
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 377
Field Description
Action Select the action to be applied to a filtered packet.
Possible values:
" (default value): The packets are forwarded on the
basis of the entries.
7,: The packets are rejected.
<K: The packets are rejected. An error message is is-
sued to the sender of the packet.
Apply QoS Only for Action = "
Select whether you want to enable QoS for this policy with the
priority selected in Priority.
The function is enabled with .
The option is deactivated by default.
If QoS is not activated for this policy, bear in mind that the data
cannot be prioritised on the sender side either.
A policy for which QoS has been enabled is also set for the fire-
wall. Make sure therefore that data traffic that has not been ex-
pressly authorised if blocked by the firewall!
Priority Only for Apply QoS = 
Select the priority with which the data specified by the policy is
handled on the send side.
Possible values:
2 (default value): No priority.
.- .,: Low Latency Transmission (LTT), i.e. hand-
ling of data with the lowest possible latency, e.g. suitable for
VoIP data.
;
=
.-
17 Firewall Teldat GmbH
364 bintec WLAN and Industrial WLAN
Przeglądanie stron 377
1 2 ... 373 374 375 376 377 378 379 380 381 382 383 ... 553 554

Komentarze do niniejszej Instrukcji

Brak uwag